Export Guide: Logic Pro

Step-by-step export settings for Logic Pro - the right way to bounce for mastering.

Step-by-step export settings for Logic Pro - the right way to bounce for mastering.

Remove any Adaptive Limiter or Multipressor from the Stereo Out channel strip Check Stereo Out meter peaks between -6 and -3 dB Set the cycle region to cover the entire song (including tails) File → Bounce → Project or Section (Cmd+B) Destination: PCM, File Format: Wave Resolution: 24-bit Sample Rate: match your project (44.1 or 48 kHz) Normalize: Off (or "Overload Protection Only" as a safety net) Dithering: None Bounce Mode: Offline (faster) or Realtime if using external hardware

Warning: Logic Pro adds an Adaptive Limiter to the Stereo Out by default in some templates. Check your Stereo Out channel strip - if you see any dynamics processing (Adaptive Limiter, Multipressor, or Limiter), bypass or remove it before bouncing.

Tip: Use "Bounce in Place" only for individual tracks, not for the final mix. For mastering, always use File → Bounce → Project or Section. If your song has reverb/delay tails that extend past the last region, extend the cycle region to capture them.

Key takeaway: File > Bounce > Project or Section. WAV, 24-bit, no normalization, no limiter on Stereo Out.